On 06/23/2015 10:22 PM, Bob Proulx wrote:
Another question: When you are connected to both as you have done what
is the output of these commands so that we can see the (as you say
broken) state of things?
ip addr show
ip route show | tac
I had a very long and nice response that I lost, as a result of an
application crash.
So, now to the specific point:
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
group default
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP
group default qlen 1000
link/ether 00:16:d3:27:29:70 brd ff:ff:ff:ff:ff:ff
inet 172.16.1.0/24 brd 172.16.1.255 scope global dynamic eth0
valid_lft 289sec preferred_lft 289sec
inet6 fe80::216:d3ff:fe27:2970/64 scope link
valid_lft forever preferred_lft forever
3: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP
group default qlen 1000
link/ether 00:13:02:b8:90:4d brd ff:ff:ff:ff:ff:ff
inet 10.10.10.5/24 brd 10.10.10.255 scope global wlan0
valid_lft forever preferred_lft forever
inet6 fe80::213:2ff:feb8:904d/64 scope link
valid_lft forever preferred_lft forever
And:
172.16.1.0/24 dev eth0 proto kernel scope link src 192.168.1.2
169.254.0.0/16 dev wlan0 scope link metric 1000
10.10.10.0/24 via 10.0.0.1 dev wlan0 proto static metric 1
10.10.10.0/24 dev wlan0 proto kernel scope link src 10.0.0.5
default via 172.16.1.1 dev eth0 proto static metric 1024
And I agree, I think this is a routing problem. And I have tried setting
static ip on wlan and Ethernet, but no luck. I changed the order as they
appear in the network/interfaces file, no luck. Set dhcp the wlan and
static for the ethernet, and did not include a gateway, no luck. I
include its gateway associated with that network, no luck.
From all that I've read, this should be very simple and
straightforward. I've followed the rules, but no luck. All I want to do
is connect to my local lan and the internet at the same time, without
having to switch to the ethernet when I want to use the lan network, and
the wifi when I want to go online. Am I the only one wanting to do this?
Thanks a lot.
--
To UNSUBSCRIBE, email to debian-user-requ...@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmas...@lists.debian.org
Archive: https://lists.debian.org/558bf839.9070...@gmx.de