Close Delphi. Check in registry at 'Known disabled packages'. If your packages are listed in that key, delete them (from that key). Start Delphi.
Jerry Clancy wrote: > Using D5 Ent. > > I am finally replacing my development system before it dies a natural death > after some 10 years+. I successfully installed D5 on the new box, transferred > some 50 .bpl files, component folders, etc., and then exported and modified > the two key KnowPackages Registry entries (in Current User and Local Machine) > to reflect the new locations (drive changes). > > I imported these modified Registry files into the new system and fired up > Delphi, which indicated missing numerous .bpl files. So, I made sure that all > the files were where they were supposed to be and with D5 open I went to > Component | Install Packages and then Added every .bpl file that was > unchecked. In the end, all packages are checked. I saved that, did a Save All > (incl. Project1.dpr) and finally exited D5 uneventfully. > > When I reopen D5 the same packages are again not found. I've repeated this > process now four times. What am I missing? There seems to be a Delphi > configuration (or some) file that is not getting changed and is doing me in. > Anyone have a clue what it might be? > > All thoughts welcome. > > Jerry > > _______________________________________________ > Delphi mailing list -> [email protected] > http://lists.elists.org/cgi-bin/mailman/listinfo/delphi > > _______________________________________________ Delphi mailing list -> [email protected] http://lists.elists.org/cgi-bin/mailman/listinfo/delphi
