On 17/04/13 12:28 PM, "Prasanna Santhanam" <[email protected]> wrote:
>On Tue, Apr 16, 2013 at 04:33:40PM -0700, Sangeetha Hariharan wrote: >> I am not able to start user Vms successfully using the build from >>master. I am testing with Xenserver 6.0.2 hosts. >> User Vm starts successfully but it gets to stopped state after few >>seconds. >> >> deployVM reports success . But later on cluster sync sees this Vm >> in stopped state and sends a StopCommand for this VM. > >It's not clustersync from the logs really. Something is going wrong on >your xenserver. I've seen this happen when the VM deployed has mem >limits outside the static-max and static-min defined by xenserver. So >anything below 64MB memory starts and then stops. Not sure if that's >the case with your deployed VM. ClusterSync in this case is only detecting that the Vms are stopped on Hypervisor and issues a stop command to clean up the state. It will be a good idea to monitor your Xenserver using Xencenter to see if the Vms are really getting stopped outside etc. I am assuming that you are not running a cluster of management servers ? -abhi > > >-- >Prasanna.,
