On 01/20/2012 10:32 AM, Adam Wang wrote:
- moved HW_VER_[0:2] to bank3
Was that absolutely necessary after you have removed HW_VER_3?
Also, note that bank 3 is 2.5V and those HW_VER resistors are still on
3.3V on your schematics. While this will not damage the FPGA, it is
cleaner to connect them to 2.5V if you really have to use bank 3.
- F2 PTC part needs to be detemined a new p/n for adapting whole
consumption protection.
What about duplicating the current circuit, and using one for USB and
the other for the rest of the board?
> * reset circuit:
FLASH_RESET_N shouldn't be connected to the FPGA anymore, and SW_RESET_N
should go to P22 (the current flash reset pin).
Also I think C238 should be removed completely (not just DNP).
And a trivial detail - the reset IC background should be yellow on the
schematics.
Sébastien
_______________________________________________
http://lists.milkymist.org/listinfo.cgi/devel-milkymist.org
IRC: #milkymist@Freenode
