On Sat, Dec 19, 2009 at 11:05 AM, Paolo Valleri <[email protected]> wrote:
> Hi,
> I compiled the package kmod-ipv6 for my fonera2.0n with this command:
> make package/kernel/{clean,compile,install} V=99
> Then, I sent & installed on the fonera the package:
> opkg -d disk install kmod-ipv6_2.6.21-fonera2n-1_mipsel.ipk
>
> you could make the "kmod-ipv6" * instead of an "M" with make menuconfig
then try run : "make V=99"
and find the ipv6 compliant "firmware" in subfolder "bin"
and flash that... you will now have the first ipv6 fonera :-)
in the next paragraph replace "fonera2" with "fonera2n" and "mips" with
mipsel to read it as "fonera 2.0n" instead of "fonera2.0g"
Built Binaries ΒΆ <http://trac.fonosfera.org/fon-ng/wiki/build#BuiltBinaries>
- Binary image are found in *~/fon-ng/trunk/openwrt/bin*:
- *loader.bin* is the second stage Meraki loader
- *openwrt-fonera2-vmlinux.image* is the kernel image
- *openwrt-fonera2.image* is the binary image of fon-ng. It contains
the rootfs and the kernel for the Fonera 2.0 and can be directly
written to
the *image* partition.
- Each file is as well available in Executable and Linkable
Format<http://en.wikipedia.org/wiki/Executable_and_Linkable_Format>
- Packages are found in *~/fon-ng/trunk/openwrt/bin/packages/mips*. Note
that both the ones included in the built image and the ones compiled as
package are there.
snippet from www.fonosfera.org -> wiki -> how to build...
_______________________________________________
Development mailing list
[email protected]
http://fonosfera.org/mailman/listinfo/development
