After the update I cannot use my usb disk (which happens to work fine with my computer):
hub 1-0:1.0: port 1 not enabled, trying reset again... hub 1-0:1.0: port_wait_reset: err = -22 hub 1-0:1.0: port 1 not enabled, trying reset again... hub 1-0:1.0: Cannot enable port 1. Maybe the USB cable is bad? hub 1-0:1.0: state 7 ports 1 chg 0000 evt 0002 hub 1-0:1.0: reset change on port 1 hub 1-0:1.0: port 1, status 0101, change 0013, 12 Mb/s hub 1-0:1.0: debounce: port 1: total 100ms stable 100ms status 0x101 hub 1-0:1.0: port_wait_reset: err = -22 hub 1-0:1.0: port 1 not enabled, trying reset again... hub 1-0:1.0: port_wait_reset: err = -22 hub 1-0:1.0: port 1 not enabled, trying reset again... hub 1-0:1.0: port_wait_reset: err = -22 hub 1-0:1.0: port 1 not enabled, trying reset again... 2013/1/2 Matthijs Kooijman - Fon <[email protected]> > Hi Kyros, > > > Thx - to change the country to GB brings you to this link: > > > https://fon.zendesk.com/entries/21439902-firmware-restore?culture=en&locale=1 > > How about to update the Link in the fonosfera blog so that this can be > > seen by everyone correctly? > Just updated the link, thanks for the suggestion! > > Regards, > > Matthijs Kooijman > > _______________________________________________ > Development mailing list > [email protected] > http://fonosfera.org/mailman/listinfo/development > -- [] Alexandre Strube [email protected]
_______________________________________________ Development mailing list [email protected] http://fonosfera.org/mailman/listinfo/development
