> Brandon,
>
> > On my 4.1 server (upgraded from 4.0.1), I want to disable all
> > telnet access. Under remote access I change the setting to no
> > access and the 'Allow administrative command line access over telnet:'
> > set to no. I save and then check my settings again ..... telnet
> > access = no access & Allow administrative command line access
> > over telnet:= yes...?
>
> Since both Charlie & Gordon will be a bit busy today, and since I
> have this hatred of telnet, I'll wade into this one...
>
> First, *are* you able to telnet into your e-smith server? If telnet
> will not let you connect, you should be safe.
No I can't telnet in - I was just reporting this issue.... I think it's just
cosmetic thing?
> Interestingly, I confirmed that this *does* occur on a new installation
> of 4.1. I went into Remote Access on my newly installed server and
> the settings were:
>
> Telnet: No access
> Admin: no
>
> I changed it to:
>
> Telnet: Private
> Admin: yes
>
> After that was successfully saved, I changed it back to 'No access'
> and 'no'... after the save, it came back as 'No access' and 'yes'.
> I tried again to change it to 'no' and it did not change.
>
> HOWEVER... I was unable to telnet into the server:
>
> telnet: Unable to connect to remote host: Connection refused
>
> and I verified that nothing was listening on port 23... so telnet
> *is* disabled through the "No Access" part of the e-smith manager.
> It appears that the "admin access" part of the web panel is not
> getting updated appropriately. I've cc'd this to "[EMAIL PROTECTED]"
> for the developers to look at.
Thanks ....
Everything else seems fine though...
Regards
BF
