On 11.08.2010 15:49, spaceyaeon wrote: > Hello, > > I am having a similar problem as mentioned by Moeller in his message. I have > made the required modifications to be USRP2 + DBSRX. All I see is a noise > floor when I try usrp2_fft.py. I am inputting 2.165 GHz signal through RF > In. Is there something that I am doing wrong? Do I need external Ref clock? > How can I do the basic test of receiving the carrier signal and displaying > it ?
I completed the instructions on the Wiki. There was no hint how to verify if the burning was correct or if the hardware was destroyed after modifying the board. I was very irritated by this. Call "usrp2_probe" to check if the board ID is 13 now. If it is still 2, the burning had no effect. I tried two times without success (didn't know that the ID would have to change). After another 3rd attempt later, I was successful. Very strange. Every time I followed the instructions exactly the same. _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio