1- I'm using the host USB not the OTG 2- I'm using the 2.6.37 kernel with Angstrom 2010 3- The following is the dmesg output which looks ok ... at least to me :)
[ 108.369293] usb 1-2.3.1: USB disconnect, address 4 [ 108.770874] usb 1-2.3.1: new high speed USB device using ehci-omap and address 6 [ 108.889404] usb 1-2.3.1: New USB device found, idVendor=fffe, idProduct=0002 [ 108.889434] usb 1-2.3.1: New USB device strings: Mfr=1, Product=2, SerialNumber=6 [ 108.889465] usb 1-2.3.1: Product: USRP Rev 4 [ 108.889465] usb 1-2.3.1: Manufacturer: Free Software Folks [ 108.889495] usb 1-2.3.1: SerialNumber: 4bd1d69b I think I'll try to attempt to redo your libusb hack by copying it from the older gnuradio recipes and attempt to use the original USRP USB driver if the problem ends up being too major ... unless you want to do that as a favor to me and push the recipe into the openembedded tree !!! pretty please :) al fayez -----Original Message----- From: Philip Balister <phi...@balister.org> To: Almohanad Fayez <alfa...@aol.com> Cc: discuss-gnuradio <discuss-gnuradio@gnu.org> Sent: Thu, Feb 24, 2011 2:20 pm Subject: Re: [Discuss-gnuradio] UHD Driver in E100/Beagleboard On 02/23/2011 11:25 PM, Almohanad Fayez wrote: > I was wondering about people's experience with the UHD driver on the E100 or the Beagleboard. I am able to use it to receive IQ data from the USRP but I can't seem to transmit anything from it ... if I take the same flowgraph to a laptop I'm able to transmit IQ using the same USRP/daughterboard and the UHD driver however when I try to run the same transmitter on the Beagleboard and I check my spectrum analyzer I don't see anything > > I already did a signal capture before sending to the USRP and made sure that there is data getting pushed through ... is there a problem with UHD/USRP sinking on the E100 and the Beagleboard ??? I also made sure that I'm using the latest UHD firmware on the beagleboard. > > > The following is the version info printed when I run the flowgraph: > linux; GNU C++ version 4.5.3 20110214 (prerelease); Boost_104500; UHD_0001.20110224034946.1 Al, Which USB port are you using to connect the USRP1? What kernel version? Can you run dmesg and see if there are any usb related messages at the end? Philip
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio