Thank you two for the prompt reply. I had forgotten to set the static IP address and once I did the problem resolved. Thank you again Brenden
On Wed, Aug 10, 2011 at 11:54 AM, Matthias Wilhelm < wilh...@informatik.uni-kl.de> wrote: > Am 10.08.2011 um 18:13 schrieb Brenden Smith: > > > Hello list, > > > > I just burned the latest UHD firmware onto the SD card I am using with my > USRP2, and when I use the "uhd_find_devices" command I am told that no > devices are found. Previously I had been using the stock firmware and I > could find the USRP2 by using the 'find_usrps' command. When I use the > 'uhd_find_devices' command the orange light on the Ethernet port (on the > USRP2) lights up briefly and then nothing happens. When I boot up the device > I get a sequence of three LEDs lighting up then a flash and the right bottom > two light remain lit. Any help with this matter would be appreciated. > > > > Thank you, > > Brenden > > Your SD card seems to boot ok. The problem may be the network settings at > the host. > The old version used raw ethernet frames, so only the correct network > device ethX was required. However, the new version uses standard IP, so you > have to set the network parameters correctly, as described in > http://www.ettus.com/uhd_docs/manual/html/usrp2.html#setup-networking > You need to be in the right network (192.168.10.0/24) to find the USRP2. > > Regards, > Matthias > >
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio