Don't quite understand your wiring. What is the "net" socket.
And where are you plugging the other end of that wire into the linksys. The correct way to use a router (linksys) as an access-point and switch is to. 1. Give it an address on the network implemented by the router that is different from the router and NOT in the router DHCP range. xxx.xxx.xxx.2 is a standard choice. 2. Turn off DHCP. 3. Set its wireless config the same as the router - with either the same or a different channel. I use different channel. 4. Connect an ether net wire from one of the lan ports on the router to one of the lan ports on the AP. The AP Wan port MUST NOT BE USED. You should be able to reach the config pages of the AP by using the address you gave it during the set up. -- Millwood 2 SB3, 1 Duet Debian Etch server 2 AP (netgear, linksys) wireless network. ------------------------------------------------------------------------ Millwood's Profile: http://forums.slimdevices.com/member.php?userid=3600 View this thread: http://forums.slimdevices.com/showthread.php?t=57663 _______________________________________________ discuss mailing list discuss@lists.slimdevices.com http://lists.slimdevices.com/lists/listinfo/discuss
