JohnSwenson wrote: > In putting together the floorplan for Gen0.5 I realized I didn't have > some important measurements, I would appreciate it if someone that > actually has a wandboard could measure these and let me know the > values. > > First is the spacing between the module board and the carrier board. > This is the "airgap" between them. Do not include any parts, just the > distance from board to board. > > Second is the distance from the module mounting holes to the alignment > pins on the connector. The connector the module plugs into has two > alignment pins the go into holes on the carrier board, one on each side > of the connector. One is larger than the other. You can easily see these > as holes on the back side of the carrier board. I would like the > distance from the center of the alignment hole to the center of the > closest module mounting hole. (this is the "X" distance, not the > diagonal distance). Just one measurement is fine, but let me know > whether it was from the smaller or larger alignment pin. > > Thanks, > > John S.
Hi John, Received my board this morning. Board to board distance 5mm and the x distance from the MxM connector location pin (large one) to first mounting pillar is 11.5mm. I'll model this up at some point this week. Norm. ------------------------------------------------------------------------ norman12's Profile: http://forums.slimdevices.com/member.php?userid=4436 View this thread: http://forums.slimdevices.com/showthread.php?t=97881 _______________________________________________ discuss mailing list discuss@lists.slimdevices.com http://lists.slimdevices.com/mailman/listinfo/discuss