It changes when I tune the VFO. In a message dated 3/31/2008 5:10:49 P.M. Eastern Daylight Time, [EMAIL PROTECTED] writes:
Garey Barrell <[EMAIL PROTECTED]> made an utterance to the drakelist gang ---------------------------------------------------------------------- 10.400 MHz ?? [EMAIL PROTECTED] wrote: > OK Garey, I must have been on the wrong pin before. The voltages on V7 > are all ok and close to where they should be in R & T. I have a scope > (Tetronix) and a Freq. counter. I am testing with the bandswitch in > the 20m position. On pin 2 of V6 I show a freq of 10.400 mhz when I go > to T and when I talk in the mike I can see the SSB signal there. > Still, nothing on the other side of V6 tho. No RF there. > > Terry > > In a message dated 3/31/2008 4:21:47 P.M. Eastern Daylight Time, > [EMAIL PROTECTED] writes: > > > Garey Barrell <[EMAIL PROTECTED]> made an utterance to the > drakelist gang > ---------------------------------------------------------------------- > OK. That's Version 1. V7 circuit is the same though. Voltage > divider > on Pin 6, screen of V7, voltage should be ~100V R or T. Likely > not the > current problem though. Perhaps you were looking at Pin 5? > > You say you have signal to the grid of V6. Is that ON Pin 2 or > ?? Are > you looking with a scope or ?? > > ---------------------------------------------------------------------- Submissions: [EMAIL PROTECTED] Unsubscribe: [EMAIL PROTECTED] - unsubscribe drakelist in body Hopelessly Lost: [EMAIL PROTECTED] - help in body of message Zerobeat Web Page: www.zerobeat.net - sponsored by www.tlchost.net ---------------------------------------------------------------------- **************Create a Home Theater Like the Pros. Watch the video on AOL Home. (http://home.aol.com/diy/home-improvement-eric-stromer?video=15&ncid=aolhom00030000000001)
