Curt -
Yep, that's it. DON'T FORGET, this cap has 250 VDC on one end and 650
VDC on the other, so be CAREFUL!!
The method described in the manual, Section VII, paragraph C. Be sure
to keep the plate current below 200 mA and keep it dipped. I find it a
little easier to first check the neutralization on 20M where the dip is
a little easier to spot, then moving to 10M where it should only take a
very small tweak to get it right on.
By the way, if you happen to have different brand tubes in the PA, do
yourself a favor and make them the same before trying to neutralize.
73, Garey - K4OAH
Glen Allen, VA
Drake 2-B, 4-B, C-Line& TR-4/C Service Supplement CDs
<www.k4oah.com>
Curt wrote:
Looking at the picture of the bottom view, where is the adjustment
screw for C-49? Near the bottom left of the PA cage just above the
V5/6 filament choke?
Also, is there PA-friendly neutralization method that doesn't require
unsoldering connections to the feed-through caps?
73, Curt KB5JO
_______________________________________________
Drakelist mailing list
Drakelist@zerobeat.net
http://mailman.zerobeat.net/mailman/listinfo/drakelist