On Fri, Jan 10, 2014 at 03:22:24PM +0100, Philipp Zabel wrote:
> Due to the voltage divider on the HPD line, the HDMI connector on
> imx6q-sabrelite doesn't reliably detect connected DVI monitors.
> This patch allows to use the RX_SENSE0 signal as a workaround when
> enabled by a boolean device tree property 'hpd-unreliable'.

If it's a fsl/imx specific property, it should have a 'fsl,' prefix.
It should be added into binding doc.  Oh, we do not even have a binding
doc for this imx-hdmi yet.

Shawn

> 
> Signed-off-by: Philipp Zabel <p.zabel at pengutronix.de>
> ---
> This patch is based on Russell's recent 46-patch imx-drm cleanup series.
> Changes since v1:
>  - Store the status and polarity bits in struct imx_hdmi
> ---
>  drivers/staging/imx-drm/imx-hdmi.c | 36 ++++++++++++++++++++++++++----------
>  1 file changed, 26 insertions(+), 10 deletions(-)
> 
> diff --git a/drivers/staging/imx-drm/imx-hdmi.c 
> b/drivers/staging/imx-drm/imx-hdmi.c
> index fb3177d..62cb531 100644
> --- a/drivers/staging/imx-drm/imx-hdmi.c
> +++ b/drivers/staging/imx-drm/imx-hdmi.c
> @@ -140,6 +140,9 @@ struct imx_hdmi {
>       struct regmap *regmap;
>       struct i2c_adapter *ddc;
>       void __iomem *regs;
> +     u8 sink_detect_polarity;
> +     u8 sink_detect_status;
> +     u8 sink_detect_mask;
>  
>       unsigned int sample_rate;
>       int ratio;
> @@ -1317,10 +1320,10 @@ static int imx_hdmi_fb_registered(struct imx_hdmi 
> *hdmi)
>                   HDMI_PHY_I2CM_CTLINT_ADDR);
>  
>       /* enable cable hot plug irq */
> -     hdmi_writeb(hdmi, (u8)~HDMI_PHY_HPD, HDMI_PHY_MASK0);
> +     hdmi_writeb(hdmi, hdmi->sink_detect_mask, HDMI_PHY_MASK0);
>  
>       /* Clear Hotplug interrupts */
> -     hdmi_writeb(hdmi, HDMI_IH_PHY_STAT0_HPD, HDMI_IH_PHY_STAT0);
> +     hdmi_writeb(hdmi, hdmi->sink_detect_status, HDMI_IH_PHY_STAT0);
>  
>       return 0;
>  }
> @@ -1392,6 +1395,7 @@ static enum drm_connector_status 
> imx_hdmi_connector_detect(struct drm_connector
>  {
>       struct imx_hdmi *hdmi = container_of(connector, struct imx_hdmi,
>                                            connector);
> +
>       return hdmi->connector_status;
>  }
>  
> @@ -1530,18 +1534,20 @@ static irqreturn_t imx_hdmi_irq(int irq, void *dev_id)
>  
>       phy_int_pol = hdmi_readb(hdmi, HDMI_PHY_POL0);
>  
> -     if (intr_stat & HDMI_IH_PHY_STAT0_HPD) {
> -             if (phy_int_pol & HDMI_PHY_HPD) {
> +     if (intr_stat & hdmi->sink_detect_status) {
> +             int pol_bit = hdmi->sink_detect_polarity;
> +
> +             if (phy_int_pol & pol_bit) {
>                       dev_dbg(hdmi->dev, "EVENT=plugin\n");
>  
> -                     hdmi_modb(hdmi, 0, HDMI_PHY_HPD, HDMI_PHY_POL0);
> +                     hdmi_modb(hdmi, 0, pol_bit, HDMI_PHY_POL0);
>  
>                       hdmi->connector_status = connector_status_connected;
>                       imx_hdmi_poweron(hdmi);
>               } else {
>                       dev_dbg(hdmi->dev, "EVENT=plugout\n");
>  
> -                     hdmi_modb(hdmi, HDMI_PHY_HPD, HDMI_PHY_HPD, 
> HDMI_PHY_POL0);
> +                     hdmi_modb(hdmi, pol_bit, pol_bit, HDMI_PHY_POL0);
>  
>                       hdmi->connector_status = connector_status_disconnected;
>                       imx_hdmi_poweroff(hdmi);
> @@ -1550,7 +1556,7 @@ static irqreturn_t imx_hdmi_irq(int irq, void *dev_id)
>       }
>  
>       hdmi_writeb(hdmi, intr_stat, HDMI_IH_PHY_STAT0);
> -     hdmi_writeb(hdmi, ~HDMI_IH_PHY_STAT0_HPD, HDMI_IH_MUTE_PHY_STAT0);
> +     hdmi_writeb(hdmi, ~hdmi->sink_detect_status, HDMI_IH_MUTE_PHY_STAT0);
>  
>       return IRQ_HANDLED;
>  }
> @@ -1702,14 +1708,24 @@ static int imx_hdmi_bind(struct device *dev, struct 
> device *master, void *data)
>        */
>       hdmi_init_clk_regenerator(hdmi);
>  
> +     hdmi->sink_detect_status = HDMI_IH_PHY_STAT0_HPD;
> +     hdmi->sink_detect_polarity = HDMI_PHY_HPD;
> +     hdmi->sink_detect_mask = ~HDMI_PHY_HPD;
> +
> +     if (of_property_read_bool(np, "hpd-unreliable")) {
> +             hdmi->sink_detect_status = HDMI_IH_PHY_STAT0_RX_SENSE0;
> +             hdmi->sink_detect_polarity = HDMI_PHY_RX_SENSE0;
> +             hdmi->sink_detect_mask = ~HDMI_PHY_RX_SENSE0;
> +     }
> +
>       /*
>        * Configure registers related to HDMI interrupt
>        * generation before registering IRQ.
>        */
> -     hdmi_writeb(hdmi, HDMI_PHY_HPD, HDMI_PHY_POL0);
> +     hdmi_writeb(hdmi, hdmi->sink_detect_polarity, HDMI_PHY_POL0);
>  
>       /* Clear Hotplug interrupts */
> -     hdmi_writeb(hdmi, HDMI_IH_PHY_STAT0_HPD, HDMI_IH_PHY_STAT0);
> +     hdmi_writeb(hdmi, hdmi->sink_detect_status, HDMI_IH_PHY_STAT0);
>  
>       ret = imx_hdmi_fb_registered(hdmi);
>       if (ret)
> @@ -1720,7 +1736,7 @@ static int imx_hdmi_bind(struct device *dev, struct 
> device *master, void *data)
>               goto err_iahb;
>  
>       /* Unmute interrupts */
> -     hdmi_writeb(hdmi, ~HDMI_IH_PHY_STAT0_HPD, HDMI_IH_MUTE_PHY_STAT0);
> +     hdmi_writeb(hdmi, ~hdmi->sink_detect_status, HDMI_IH_MUTE_PHY_STAT0);
>  
>       ret = snd_dw_hdmi_probe(&hdmi->audio, dev, hdmi->regs, irq, hdmi);
>       if (ret)
> -- 
> 1.8.5.2
> 

Reply via email to