This patch is invalid now that Mike Turquette took the generic
clk-gpio-gate in. The other patches in the series are still Ok.
I'll mail a new dts patch shortly.
Best regards,
Jyri
On 09/16/2014 11:40 PM, Jyri Sarha wrote:
> Adds mcasp0_pins, clk_mcasp0_fixed, clk_mcasp0, mcasp0, hdmi_audio,
> and sound nodes.
>
> Signed-off-by: Jyri Sarha <jsarha at ti.com>
> ---
> arch/arm/boot/dts/am335x-boneblack.dts | 52
> ++++++++++++++++++++++++++++++++
> 1 file changed, 52 insertions(+)
>
> diff --git a/arch/arm/boot/dts/am335x-boneblack.dts
> b/arch/arm/boot/dts/am335x-boneblack.dts
> index 305975d..1487f7c 100644
> --- a/arch/arm/boot/dts/am335x-boneblack.dts
> +++ b/arch/arm/boot/dts/am335x-boneblack.dts
> @@ -59,12 +59,35 @@
> 0x1b0 0x03 /* xdma_event_intr0, OMAP_MUX_MODE3 |
> AM33XX_PIN_OUTPUT */
> >;
> };
> +
> + mcasp0_pins: mcasp0_pins {
> + pinctrl-single,pins = <
> + 0x1ac (PIN_INPUT_PULLUP | MUX_MODE0) /*
> mcasp0_ahclkx.mcasp0_ahclkx */
> + 0x19c (PIN_OUTPUT_PULLDOWN | MUX_MODE2) /*
> mcasp0_ahclkr.mcasp0_axr2 */
> + 0x194 (PIN_OUTPUT_PULLUP | MUX_MODE0) /*
> mcasp0_fsx.mcasp0_fsx */
> + 0x190 (PIN_OUTPUT_PULLDOWN | MUX_MODE0) /*
> mcasp0_aclkx.mcasp0_aclkx */
> + 0x06c (PIN_OUTPUT_PULLDOWN | MUX_MODE7) /*
> gpmc_a11.GPIO1_27 */
> + >;
> + };
> };
>
> &lcdc {
> status = "okay";
> };
>
> +&mcasp0 {
> + pinctrl-names = "default";
> + pinctrl-0 = <&mcasp0_pins>;
> + status = "okay";
> + op-mode = <0>; /* MCASP_IIS_MODE */
> + tdm-slots = <2>;
> + serial-dir = < /* 0: INACTIVE, 1: TX, 2: RX */
> + 0 0 1 0
> + >;
> + tx-num-evt = <1>;
> + rx-num-evt = <1>;
> +};
> +
> / {
> hdmi {
> compatible = "ti,tilcdc,slave";
> @@ -74,4 +97,33 @@
> pinctrl-1 = <&nxp_hdmi_bonelt_off_pins>;
> status = "okay";
> };
> +
> + clk_mcasp0_fixed: clk_mcasp0_fixed {
> + #clock-cells = <0>;
> + compatible = "fixed-clock";
> + clock-frequency = <24576000>;
> + };
> +
> + clk_mcasp0: clk_mcasp0 {
> + #clock-cells = <0>;
> + compatible = "ti,gpio-gate-clock";
> + clocks = <&clk_mcasp0_fixed>;
> + enable-gpios = <&gpio1 27 0>; /* BeagleBone Black Clk enable on
> GPIO1_27 */
> + };
> +
> + hdmi_audio: hdmi_audio at 0 {
> + compatible = "linux,hdmi-audio";
> + status = "okay";
> + };
> +
> + sound {
> + compatible = "ti,beaglebone-black-audio";
> + ti,model = "TI BeagleBone Black";
> + ti,audio-codec = <&hdmi_audio>;
> + ti,mcasp-controller = <&mcasp0>;
> + ti,audio-routing =
> + "HDMI Out", "TX";
> + clocks = <&clk_mcasp0>;
> + clock-names = "mclk";
> + };
> };
>
