On Tue, Jan 15, 2019 at 10:49:51AM +0100, Maxime Ripard wrote: > Hi, > > (Sending those kind of bug reports to linux-sunxi doesn't really work, > you should Cc at least the ML involved in the development of the > driver at fault).
OK, sorry for that. > > On Mon, Jan 14, 2019 at 01:29:34PM +0000, Priit Laes wrote: > > I have a somewhat curious case with one HDMI/DVI screen that fails > > to initialize properly every 6-7 boots. The display itself is also > > somewhat flawed (missing HPD pin and the VSYNC/HSYNC pulse width > > is set to 0 in EDID), but I suspect there could be some issues > > regarding timing in A20 HDMI driver in Linux. > > ... > It doesn't look related to the clock rate itself, since it doesn't > change between the two cases. However, in one case the DDC clock is > enabled and in the other it's disabled. > > Was it taken at the same time? Maybe you can try with that patch? > http://code.bulix.org/z7jmkm-555344?raw Thanks, after doing ~50+ boots I haven't seen a single failure. Previously I had following failure cases which are now both fixed: a) Linux without u-boot HDMI, where one in every 6-7 boots failed. b) u--boot with hdmi enabled switching to simplefb and then switching to kms, where previously all boots ended up with garbled screen. Priit :) > > Maxime > > -- > Maxime Ripard, Bootlin > Embedded Linux and Kernel engineering > https://bootlin.com > > -- > You received this message because you are subscribed to the Google Groups > "linux-sunxi" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to linux-sunxi+unsubscr...@googlegroups.com. > For more options, visit https://groups.google.com/d/optout. _______________________________________________ dri-devel mailing list dri-devel@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/dri-devel
