From: Ondrej Jirman <meg...@megous.com>

Orange Pi 3 has a DDC_CEC_EN signal connected to PH2, that enables the DDC
I2C bus voltage shifter. Before EDID can be read, we need to pull PH2 high.
This is realized by the ddc-en-gpios property.

Signed-off-by: Ondrej Jirman <meg...@megous.com>
---
 .../dts/allwinner/sun50i-h6-orangepi-3.dts    | 26 +++++++++++++++++++
 1 file changed, 26 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts 
b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
index 2c6807b74ff6..01bb1bafe284 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h6-orangepi-3.dts
@@ -22,6 +22,18 @@
                stdout-path = "serial0:115200n8";
        };
 
+       connector {
+               compatible = "hdmi-connector";
+               ddc-en-gpios = <&pio 7 2 GPIO_ACTIVE_HIGH>; /* PH2 */
+               type = "a";
+
+               port {
+                       hdmi_con_in: endpoint {
+                               remote-endpoint = <&hdmi_out_con>;
+                       };
+               };
+       };
+
        leds {
                compatible = "gpio-leds";
 
@@ -72,6 +84,10 @@
        cpu-supply = <&reg_dcdca>;
 };
 
+&de {
+       status = "okay";
+};
+
 &ehci0 {
        status = "okay";
 };
@@ -91,6 +107,16 @@
        status = "okay";
 };
 
+&hdmi {
+       status = "okay";
+};
+
+&hdmi_out {
+       hdmi_out_con: endpoint {
+               remote-endpoint = <&hdmi_con_in>;
+       };
+};
+
 &mdio {
        ext_rgmii_phy: ethernet-phy@1 {
                compatible = "ethernet-phy-ieee802.3-c22";
-- 
2.21.0

Reply via email to