On Fri, Jun 14, 2019 at 8:53 AM Robert Chiras <robert.chi...@nxp.com> wrote:
>
> Add dt-bindings documentation for Raydium RM67191 DSI panel.
>
> Signed-off-by: Robert Chiras <robert.chi...@nxp.com>
> ---
>  .../bindings/display/panel/raydium,rm67191.txt     | 42 
> ++++++++++++++++++++++
>  1 file changed, 42 insertions(+)
>  create mode 100644 
> Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
>
> diff --git 
> a/Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt 
> b/Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
> new file mode 100644
> index 0000000..5a6268d
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/display/panel/raydium,rm67191.txt
> @@ -0,0 +1,42 @@
> +Raydium RM67171 OLED LCD panel with MIPI-DSI protocol
> +
> +Required properties:
> +- compatible:          "raydium,rm67191"
> +- reg:                 virtual channel for MIPI-DSI protocol
> +                       must be <0>
> +- dsi-lanes:           number of DSI lanes to be used
> +                       must be <3> or <4>
> +- port:                input port node with endpoint definition as
> +                       defined in 
> Documentation/devicetree/bindings/graph.txt;
> +                       the input port should be connected to a MIPI-DSI 
> device
> +                       driver
> +
> +Optional properties:
> +- reset-gpio:          a GPIO spec for the RST_B GPIO pin

reset-gpios (with the s in the end) is the recommendation.

> +- display-timings:     timings for the connected panel according to [1]

This is not needed.

> +- video-mode:          0 - burst-mode
> +                       1 - non-burst with sync event
> +                       2 - non-burst with sync pulse
> +
> +[1]: Documentation/devicetree/bindings/display/display-timing.txt

This path does not exist.

Also, could you try to align these bindings with the one from raydium,rm68200?

There are power-supply and backlight optional properties there, which
seem useful.

> +
> +Example:
> +
> +       panel@0 {
> +               compatible = "raydium,rm67191";
> +               reg = <0>;
> +               pinctrl-0 = <&pinctrl_mipi_dsi_0_1_en>;

You should also pass pinctrl-names = "default"; if you use pinctrl-0.

> +               reset-gpio = <&gpio1 7 GPIO_ACTIVE_HIGH>;

Should be active low.
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel

Reply via email to