On Wed, Aug 07, 2019 at 02:02:54PM +0800, Jitao Shi wrote: > Add decriptions about supported chips, including MT2701 & MT8173 & > mt8183 > > Signed-off-by: Jitao Shi <jitao....@mediatek.com> > --- > .../bindings/display/mediatek/mediatek,dpi.txt | 11 +++++++++++ > 1 file changed, 11 insertions(+) > > diff --git > a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt > b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt > index b6a7e7397b8b..cd6a1469c8b7 100644 > --- a/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt > +++ b/Documentation/devicetree/bindings/display/mediatek/mediatek,dpi.txt > @@ -7,6 +7,7 @@ output bus. > > Required properties: > - compatible: "mediatek,<chip>-dpi" > + the supported chips are mt2701 , mt8173 and mt8183. > - reg: Physical base address and length of the controller's registers > - interrupts: The interrupt signal from the function block. > - clocks: device clocks > @@ -16,6 +17,11 @@ Required properties: > Documentation/devicetree/bindings/graph.txt. This port should be connected > to the input port of an attached HDMI or LVDS encoder chip. > > +Optional properties: > +- dpi_pin_mode_swap: Swap the pin mode between dpi mode and gpio mode. > +- pinctrl-names: Contain "gpiomode" and "dpimode". > +- dpi_dual_edge: Control the RGB 24bit data on 12 pins or 24 pins.
Nothing about this in the commit msg... The dpi* properties need vendor prefixes and use '-' rather than '_'. Rob _______________________________________________ dri-devel mailing list dri-devel@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/dri-devel
