On 12/02/2020 06:26, Yuti Amonkar wrote:
This patch adds new DRM driver for Cadence MHDP DPTX IP used on J721e SoC.
MHDP DPTX IP is the component that complies with VESA DisplayPort (DP) and
embedded Display Port (eDP) standards. It integrates uCPU running the
embedded Firmware(FW) interfaced over APB interface.
Basically, it takes a DPI stream as input and output it encoded in DP
format. Currently, it supports only SST mode.
Signed-off-by: Yuti Amonkar <yamon...@cadence.com>
Signed-off-by: Jyri Sarha <jsa...@ti.com>
---
drivers/gpu/drm/bridge/Kconfig | 11 +
drivers/gpu/drm/bridge/Makefile | 3 +
drivers/gpu/drm/bridge/cdns-mhdp-core.c | 2206 +++++++++++++++++++++++
drivers/gpu/drm/bridge/cdns-mhdp-core.h | 380 ++++
4 files changed, 2600 insertions(+)
create mode 100644 drivers/gpu/drm/bridge/cdns-mhdp-core.c
create mode 100644 drivers/gpu/drm/bridge/cdns-mhdp-core.h
diff --git a/drivers/gpu/drm/bridge/Kconfig b/drivers/gpu/drm/bridge/Kconfig
index 8397bf72d2f3..c66f2ef04f71 100644
--- a/drivers/gpu/drm/bridge/Kconfig
+++ b/drivers/gpu/drm/bridge/Kconfig
@@ -27,6 +27,17 @@ config DRM_CDNS_DSI
Support Cadence DPI to DSI bridge. This is an internal
bridge and is meant to be directly embedded in a SoC.
+config DRM_CDNS_MHDP
+ tristate "Cadence DPI/DP bridge"
+ select DRM_KMS_HELPER
+ select DRM_PANEL_BRIDGE
+ depends on OF
+ help
+ Support Cadence DPI to DP bridge. This is an internal
+ bridge and is meant to be directly embedded in a SoC.
+ It takes a DPI stream as input and output it encoded
+ in DP format.
+
config DRM_DUMB_VGA_DAC
tristate "Dumb VGA DAC Bridge support"
depends on OF
diff --git a/drivers/gpu/drm/bridge/Makefile b/drivers/gpu/drm/bridge/Makefile
index 1eb5376c5d68..71019088d257 100644
--- a/drivers/gpu/drm/bridge/Makefile
+++ b/drivers/gpu/drm/bridge/Makefile
@@ -15,6 +15,9 @@ obj-$(CONFIG_DRM_TOSHIBA_TC358767) += tc358767.o
obj-$(CONFIG_DRM_I2C_ADV7511) += adv7511/
obj-$(CONFIG_DRM_TI_SN65DSI86) += ti-sn65dsi86.o
obj-$(CONFIG_DRM_TI_TFP410) += ti-tfp410.o
+obj-$(CONFIG_DRM_CDNS_MHDP) += cdns-mhdp.o
obj-y += analogix/
obj-y += synopsys/
+
+cdns-mhdp-objs := cdns-mhdp-core.o
I think it's better to keep the two lines added in this change together, instead of having those
other obj-y lines in between.
diff --git a/drivers/gpu/drm/bridge/cdns-mhdp-core.c
b/drivers/gpu/drm/bridge/cdns-mhdp-core.c
new file mode 100644
index 000000000000..51ed9cdee161
--- /dev/null
+++ b/drivers/gpu/drm/bridge/cdns-mhdp-core.c
@@ -0,0 +1,2206 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Cadence MHDP DP bridge driver.
+ *
+ * Copyright: 2019 Cadence Design Systems, Inc.
+ *
+ * Author: Quentin Schulz <quentin.sch...@free-electrons.com>
Author is Quentin, but there's no signed-off-by from him? There are also many names in
MODULE_AUTHOR, without signed-off-bys.
I think the rule is that you should have signed-off-bys for people who have contributed. I'm not
sure how strict that rule is, and what to do if the people cannot be reached anymore.
<snip>
+static int mhdp_probe(struct platform_device *pdev)
+{
+ const struct of_device_id *match;
+ struct resource *regs;
+ struct cdns_mhdp_device *mhdp;
+ struct clk *clk;
+ int ret;
+ unsigned long rate;
+ int irq;
+ u32 lanes_prop;
+ unsigned int link_rate;
+
+ mhdp = devm_kzalloc(&pdev->dev, sizeof(struct cdns_mhdp_device),
+ GFP_KERNEL);
+ if (!mhdp)
+ return -ENOMEM;
+
+ clk = devm_clk_get(&pdev->dev, NULL);
+ if (IS_ERR(clk)) {
+ dev_err(&pdev->dev, "couldn't get clk: %ld\n", PTR_ERR(clk));
+ return PTR_ERR(clk);
+ }
+
+ mhdp->clk = clk;
+ mhdp->dev = &pdev->dev;
+ mhdp->conn_bus_flags_defaults = DRM_BUS_FLAG_DE_HIGH;
+ mutex_init(&mhdp->mbox_mutex);
+ spin_lock_init(&mhdp->start_lock);
+ dev_set_drvdata(&pdev->dev, mhdp);
+
+ drm_dp_aux_init(&mhdp->aux);
+ mhdp->aux.dev = &pdev->dev;
+ mhdp->aux.transfer = mhdp_transfer;
+
+ regs = platform_get_resource(pdev, IORESOURCE_MEM, 0);
+ mhdp->regs = devm_ioremap_resource(&pdev->dev, regs);
+ if (IS_ERR(mhdp->regs))
+ return PTR_ERR(mhdp->regs);
+
+ mhdp->phy = devm_of_phy_get_by_index(&pdev->dev, pdev->dev.of_node, 0);
+ if (IS_ERR(mhdp->phy)) {
+ dev_err(&pdev->dev, "no PHY configured\n");
+ return PTR_ERR(mhdp->phy);
+ }
+
+ platform_set_drvdata(pdev, mhdp);
+
+ clk_prepare_enable(clk);
+
+ match = of_match_device(mhdp_ids, &pdev->dev);
+ if (!match)
+ return -ENODEV;
+ mhdp->ops = (struct mhdp_platform_ops *)match->data;
+
+ pm_runtime_enable(&pdev->dev);
+ ret = pm_runtime_get_sync(&pdev->dev);
+ if (ret < 0) {
+ dev_err(&pdev->dev, "pm_runtime_get_sync failed\n");
+ pm_runtime_disable(&pdev->dev);
+ goto clk_disable;
+ }
+
+ if (mhdp->ops && mhdp->ops->init) {
+ ret = mhdp->ops->init(mhdp);
+ if (ret != 0) {
+ dev_err(&pdev->dev, "MHDP platform initialization failed:
%d\n",
+ ret);
+ goto runtime_put;
+ }
+ }
+
+ rate = clk_get_rate(clk);
+ writel(rate % 1000000, mhdp->regs + CDNS_SW_CLK_L);
+ writel(rate / 1000000, mhdp->regs + CDNS_SW_CLK_H);
+
+ dev_dbg(&pdev->dev, "func clk rate %lu Hz\n", rate);
+
+ writel(~0, mhdp->regs + CDNS_MB_INT_MASK);
+ writel(~0, mhdp->regs + CDNS_APB_INT_MASK);
+
+ irq = platform_get_irq(pdev, 0);
+ ret = devm_request_threaded_irq(mhdp->dev, irq, NULL, mhdp_irq_handler,
+ IRQF_ONESHOT, "mhdp8546", mhdp);
+ if (ret) {
+ dev_err(&pdev->dev, "cannot install IRQ %d\n", irq);
+ ret = -EIO;
+ goto plat_fini;
+ }
+
+ /* Read source capabilities, based on PHY's device tree properties. */
+ ret = device_property_read_u32(&mhdp->phy->dev, "cdns,num-lanes",
+ &(lanes_prop));
+ if (ret)
+ mhdp->host.lanes_cnt = CDNS_LANE_4;
+ else
+ mhdp->host.lanes_cnt = lanes_prop;
+
+ ret = device_property_read_u32(&mhdp->phy->dev, "cdns,max-bit-rate",
+ &(link_rate));
+ if (ret)
+ link_rate = drm_dp_bw_code_to_link_rate(DP_LINK_BW_8_1);
+ else
+ /* PHY uses Mb/s, DRM uses tens of kb/s. */
+ link_rate *= 100;
+
+ mhdp->host.link_rate = link_rate;
+ mhdp->host.volt_swing = CDNS_VOLT_SWING(3);
+ mhdp->host.pre_emphasis = CDNS_PRE_EMPHASIS(3);
+ mhdp->host.pattern_supp = CDNS_SUPPORT_TPS(1) |
+ CDNS_SUPPORT_TPS(2) | CDNS_SUPPORT_TPS(3) |
+ CDNS_SUPPORT_TPS(4);
+ mhdp->host.lane_mapping = CDNS_LANE_MAPPING_NORMAL;
+ mhdp->host.fast_link = false;
+ mhdp->host.enhanced = true;
+ mhdp->host.scrambler = true;
+ mhdp->host.ssc = false;
+
+ /* The only currently supported format */
+ mhdp->display_fmt.y_only = false;
+ mhdp->display_fmt.color_format = DRM_COLOR_FORMAT_RGB444;
+ mhdp->display_fmt.bpc = 8;
+
+ mhdp->bridge.of_node = pdev->dev.of_node;
+ mhdp->bridge.funcs = &cdns_mhdp_bridge_funcs;
+
+ ret = phy_init(mhdp->phy);
+ if (ret) {
+ dev_err(mhdp->dev, "Failed to initialize PHY: %d\n", ret);
+ goto runtime_put;
+ }
+
+ ret = load_firmware(mhdp);
+ if (ret)
+ goto phy_exit;
+
+ drm_bridge_add(&mhdp->bridge);
+
+ return 0;
+
+phy_exit:
+ phy_exit(mhdp->phy);
+plat_fini:
+ if (mhdp->ops && mhdp->ops->exit)
+ mhdp->ops->exit(mhdp);
+runtime_put:
+ pm_runtime_put_sync(&pdev->dev);
+ pm_runtime_disable(&pdev->dev);
+clk_disable:
+ clk_disable_unprepare(mhdp->clk);
+
+ return ret;
+}
+
+MODULE_FIRMWARE(FW_NAME);
+
+static int mhdp_remove(struct platform_device *pdev)
+{
+ struct cdns_mhdp_device *mhdp = dev_get_drvdata(&pdev->dev);
+ unsigned int timeout = 10;
+ bool stop_fw = false;
+ int ret = 0;
+
+ if (mhdp->ops && mhdp->ops->exit)
+ mhdp->ops->exit(mhdp);
+
+ drm_bridge_remove(&mhdp->bridge);
+
+wait_loading:
+ spin_lock(&mhdp->start_lock);
+ if (mhdp->hw_state == MHDP_HW_LOADING && timeout-- > 0) {
+ spin_unlock(&mhdp->start_lock);
+ msleep(100);
+ goto wait_loading;
+ } else if (mhdp->hw_state == MHDP_HW_READY) {
+ stop_fw = true;
+ timeout = 1; /* We were successful even if counter reached 0 */
+ }
+ mhdp->hw_state = MHDP_HW_STOPPED;
+ spin_unlock(&mhdp->start_lock);
+
+ if (timeout == 0)
+ dev_err(mhdp->dev, "%s: Timeout waiting for fw loading\n",
+ __func__);
+
+ if (stop_fw) {
+ ret = cdns_mhdp_set_firmware_active(mhdp, false);
+ if (ret)
+ dev_err(mhdp->dev, "%s: De-activate FW failed: %d\n",
+ __func__, ret);
+ }
+
+ phy_exit(mhdp->phy);
+
+ pm_runtime_put_sync(&pdev->dev);
+ pm_runtime_disable(&pdev->dev);
+
+ clk_disable_unprepare(mhdp->clk);
+
+ /* FIXME: check for missing functions */
+
+ return ret;
+}
The sequence here does not match what's done at probe()'s error handling. It
probably should.
The FIXME here sounds something that has to be fixed (or removed).
There were also a few FIXMEs in the code, I think think it would be good to review all those, and
see if they're still valid, and perhaps add a bit more explanation to each.
+/* mailbox */
+#define MAILBOX_RETRY_US 1000
+#define MAILBOX_TIMEOUT_US 5000000
This is 5 seconds. It sounds pretty long time to wait in a blocking function.
Tomi
--
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki.
Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
_______________________________________________
dri-devel mailing list
dri-devel@lists.freedesktop.org
https://lists.freedesktop.org/mailman/listinfo/dri-devel
