Hi Eric, On Tue, Jun 02, 2020 at 12:31:37PM -0700, Eric Anholt wrote: > On Tue, Jun 2, 2020 at 8:02 AM Dave Stevenson > <dave.steven...@raspberrypi.com> wrote: > > > > Hi Maxime and Eric > > > > On Tue, 2 Jun 2020 at 15:12, Maxime Ripard <max...@cerno.tech> wrote: > > > > > > Hi Eric > > > > > > On Wed, May 27, 2020 at 09:54:44AM -0700, Eric Anholt wrote: > > > > On Wed, May 27, 2020 at 8:50 AM Maxime Ripard <max...@cerno.tech> wrote: > > > > > > > > > > The VIDEN bit in the pixelvalve currently being used to enable or > > > > > disable > > > > > the pixelvalve seems to not be enough in some situations, which whill > > > > > end > > > > > up with the pixelvalve stalling. > > > > > > > > > > In such a case, even re-enabling VIDEN doesn't bring it back and we > > > > > need to > > > > > clear the FIFO. This can only be done if the pixelvalve is disabled > > > > > though. > > > > > > > > > > In order to overcome this, we can configure the pixelvalve during > > > > > mode_set_no_fb, but only enable it in atomic_enable and flush the FIFO > > > > > there, and in atomic_disable disable the pixelvalve again. > > > > > > > > What displays has this been tested with? Getting this sequencing > > > > right is so painful, and things like DSI are tricky to get to light > > > > up. > > > > > > That FIFO is between the HVS and the HDMI PVs, so this was obviously > > > tested against that. Dave also tested the DSI output IIRC, so we should > > > be covered here. > > > > DSI wasn't working on the first patch set that Maxime sent - I haven't > > tested this one as yet but will do so. > > DPI was working early on to both an Adafruit 800x480 DPI panel, and > > via a VGA666 as VGA. > > HDMI is obviously working. > > VEC is being ignored now. The clock structure is more restricted than > > earlier chips, so to get the required clocks for the VEC without using > > fractional divides it compromises the clock that other parts of the > > system can run at (IIRC including the ARM). That's why the VEC has to > > be explicitly enabled for the firmware to enable it as the only > > output. It's annoying, but that's just a restriction of the chip. > > I'm more concerned with "make sure we don't regress pre-pi4 with this > series" than "pi4 displays all work from the beginning"
I tested the DSI today on an RPI3, and I had to fix an issue with the HVS-PV muxing, but otherwise it works with this series. Otherwise, the HDMI and TXP work on the Pi3 too, I'll give a try to the VGA adapter on it next week to test DPI too. As a side note, my DSI display without my patches gives DSI transfer timeouts at boot, since at least (mainline) 5.4, I haven't tested further back. It just stalls the modeset for a while, but the display works fine after that. Does that ring any bell? Maxime
signature.asc
Description: PGP signature
_______________________________________________ dri-devel mailing list dri-devel@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/dri-devel