Hi Alex. On Mon, Sep 28, 2020 at 12:35:01PM -0500, Alex G. wrote: > On 9/26/20 1:49 PM, Sam Ravnborg wrote: > > Hi Alexandru > > > > On Thu, Sep 24, 2020 at 03:05:05PM -0500, Alexandru Gagniuc wrote: > > > On the SII9022, the IOVCC and CVCC12 supplies must reach the correct > > > voltage before the reset sequence is initiated. On most boards, this > > > assumption is true at boot-up, so initialization succeeds. > > > > > > However, when we try to initialize the chip with incorrect supply > > > voltages, it will not respond to I2C requests. sii902x_probe() fails > > > with -ENXIO. > > > > > > To resolve this, look for the "iovcc" and "cvcc12" regulators, and > > > make sure they are enabled before starting the reset sequence. If > > > these supplies are not available in devicetree, then they will default > > > to dummy-regulator. In that case everything will work like before. > > > > > > This was observed on a STM32MP157C-DK2 booting in u-boot falcon mode. > > > On this board, the supplies would be set by the second stage > > > bootloader, which does not run in falcon mode. > > > > > > Signed-off-by: Alexandru Gagniuc <mr.nuke...@gmail.com> > > > > One nitpick here. The binding should be present in the tree before > > you start using it. So this patch should be applied after the binding. > > It is :) > * arch/arm/boot/dts/stm32mp15xx-dkx.dtsi
This is the device tree. So essentially there is part of the device tree that is not yet documented - so in a perfect world all parts of the device tree is documented in bindings (Documentation/devicetree/bindings/* ) before the device tree is committed. Sam _______________________________________________ dri-devel mailing list dri-devel@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/dri-devel