Hi, On 23/04/2021 11:26, Liu Ying wrote: > Hi, > > This series aims to make the nwl-dsi bridge be able to connect with > more MIPI DSI panels. Some MIPI DSI panel drivers like 'raydium,rm68200' > send MIPI_DCS_SET_DISPLAY_ON commands in panel_funcs->prepare(), which > requires the MIPI DSI controller and PHY to be ready beforehand. > However, the existing nwl-dsi driver gets the MIPI DSI controller and > PHY ready in bridge_funcs->pre_enable(), which happens after the > panel_funcs->prepare(). So, this series shifts the bridge operation > ealier from bridge_funcs->pre_enable() to bridge_funcs->mode_set(). > > Patch 3/3 does the essential bridge operation shift. > > Patch 1/3 and 2/3 are split from the original single patch in v2 and > are needed by patch 3/3. This split-up helps clarify changes better. > The split-up is done in this way: > > 1) Patch 1/3 forces a full modeset when crtc_state->active is changed to > be true(which implies only connector's DPMS is brought out of "Off" > status, though not necessarily). This makes sure ->mode_set() and > ->atomic_disable() will be called in pairs. > 2) Patch 2/3 removes a check on unchanged HS clock rate from ->mode_set(), > to make sure MIPI DSI controller and PHY are brought up and taken down > in pairs. > 3) Patch 3/3 shifts the bridge operation as the last step. > > > v2->v3: > * Split the single patch in v2 into 3 patches. (Neil) > > v1->v2: > * Fix a typo in commit message - s/unchange/unchanged/ > > > Liu Ying (3): > drm/bridge: nwl-dsi: Force a full modeset when crtc_state->active is > changed to be true > drm/bridge: nwl-dsi: Remove a check on unchanged HS clock rate from > ->mode_set() > drm/bridge: nwl-dsi: Get MIPI DSI controller and PHY ready in > ->mode_set() > > drivers/gpu/drm/bridge/nwl-dsi.c | 86 +++++++++++++++++--------------- > 1 file changed, 46 insertions(+), 40 deletions(-) >
The patchset looks fine, I'll leave a few days for Laurent or Rob to eventually comment. Thanks, Neil _______________________________________________ dri-devel mailing list dri-devel@lists.freedesktop.org https://lists.freedesktop.org/mailman/listinfo/dri-devel
