From: Vladimir Lypak <vladimir.ly...@gmail.com>
There is currently two function for performing reset: dsi_sw_reset and
dsi_sw_reset_restore. Only difference betwean those is that latter one
assumes that DSI controller is enabled. In contrary former one assumes
that controller is disabled and executed during power-on. However this
assumtion is not true mobile devices which have boot splash set up by
boot-loader.
This patch removes dsi_sw_reset_restore and makes dsi_sw_reset disable
DSI controller during reset sequence if it's enabled.
Signed-off-by: Vladimir Lypak <vladimir.ly...@gmail.com>
Signed-off-by: Luca Weiss <l...@z3ntu.xyz>
---
drivers/gpu/drm/msm/dsi/dsi_host.c | 48 +++++++++++++-----------------
1 file changed, 21 insertions(+), 27 deletions(-)
diff --git a/drivers/gpu/drm/msm/dsi/dsi_host.c
b/drivers/gpu/drm/msm/dsi/dsi_host.c
index a95d5df52653..bab2634ebd11 100644
--- a/drivers/gpu/drm/msm/dsi/dsi_host.c
+++ b/drivers/gpu/drm/msm/dsi/dsi_host.c
@@ -1080,12 +1080,32 @@ static void dsi_timing_setup(struct msm_dsi_host
*msm_host, bool is_bonded_dsi)
static void dsi_sw_reset(struct msm_dsi_host *msm_host)
{
+ u32 ctrl;
+
+ ctrl = dsi_read(msm_host, REG_DSI_CTRL);
+
+ if (ctrl & DSI_CTRL_ENABLE) {
+ dsi_write(msm_host, REG_DSI_CTRL, ctrl & ~DSI_CTRL_ENABLE);
+ /*
+ * dsi controller need to be disabled before
+ * clocks turned on
+ */
+ wmb();
+ }
+
dsi_write(msm_host, REG_DSI_CLK_CTRL, DSI_CLK_CTRL_ENABLE_CLKS);
wmb(); /* clocks need to be enabled before reset */
+ /* dsi controller can only be reset while clocks are running */
dsi_write(msm_host, REG_DSI_RESET, 1);
msleep(DSI_RESET_TOGGLE_DELAY_MS); /* make sure reset happen */
dsi_write(msm_host, REG_DSI_RESET, 0);
+ wmb(); /* controller out of reset */
+
+ if (ctrl & DSI_CTRL_ENABLE) {
+ dsi_write(msm_host, REG_DSI_CTRL, ctrl);
+ wmb(); /* make sure dsi controller enabled again */
+ }
}
static void dsi_op_mode_config(struct msm_dsi_host *msm_host,
@@ -1478,32 +1498,6 @@ static int dsi_cmds2buf_tx(struct msm_dsi_host *msm_host,
return len;
}
-static void dsi_sw_reset_restore(struct msm_dsi_host *msm_host)
-{
- u32 data0, data1;
-
- data0 = dsi_read(msm_host, REG_DSI_CTRL);
- data1 = data0;
- data1 &= ~DSI_CTRL_ENABLE;
- dsi_write(msm_host, REG_DSI_CTRL, data1);
- /*
- * dsi controller need to be disabled before
- * clocks turned on
- */
- wmb();
-
- dsi_write(msm_host, REG_DSI_CLK_CTRL, DSI_CLK_CTRL_ENABLE_CLKS);
- wmb(); /* make sure clocks enabled */
-
- /* dsi controller can only be reset while clocks are running */
- dsi_write(msm_host, REG_DSI_RESET, 1);
- msleep(DSI_RESET_TOGGLE_DELAY_MS); /* make sure reset happen */
- dsi_write(msm_host, REG_DSI_RESET, 0);
- wmb(); /* controller out of reset */
- dsi_write(msm_host, REG_DSI_CTRL, data0);
- wmb(); /* make sure dsi controller enabled again */
-}
-
static void dsi_hpd_worker(struct work_struct *work)
{
struct msm_dsi_host *msm_host =
@@ -1520,7 +1514,7 @@ static void dsi_err_worker(struct work_struct *work)
pr_err_ratelimited("%s: status=%x\n", __func__, status);
if (status & DSI_ERR_STATE_MDP_FIFO_UNDERFLOW)
- dsi_sw_reset_restore(msm_host);
+ dsi_sw_reset(msm_host);
/* It is safe to clear here because error irq is disabled. */
msm_host->err_work_state = 0;
--
2.36.1
