In the event a device is connected to the samsung-dsim controller that doesn't support the burst-clock, the driver is able to get the requested pixel clock from the attached device or bridge. In these instances, the samsung,burst-clock-frequency isn't needed, so remove it from the required list.
The pll-clock frequency can be set by the device tree entry for samsung,pll-clock-frequency, but in some cases, the pll-clock may have the same clock rate as sclk_mipi clock. If they are equal, this flag is not needed since the driver will use the sclk_mipi rate as a fallback. Signed-off-by: Adam Ford <aford...@gmail.com> --- .../bindings/display/bridge/samsung,mipi-dsim.yaml | 9 +++++---- 1 file changed, 5 insertions(+), 4 deletions(-) diff --git a/Documentation/devicetree/bindings/display/bridge/samsung,mipi-dsim.yaml b/Documentation/devicetree/bindings/display/bridge/samsung,mipi-dsim.yaml index 9f61ebdfefa8..360fea81f4b6 100644 --- a/Documentation/devicetree/bindings/display/bridge/samsung,mipi-dsim.yaml +++ b/Documentation/devicetree/bindings/display/bridge/samsung,mipi-dsim.yaml @@ -70,7 +70,9 @@ properties: samsung,burst-clock-frequency: $ref: /schemas/types.yaml#/definitions/uint32 description: - DSIM high speed burst mode frequency. + DSIM high speed burst mode frequency when connected to devices + that support burst mode. If absent, the driver will use the pixel + clock from the attached device or bridge. samsung,esc-clock-frequency: $ref: /schemas/types.yaml#/definitions/uint32 @@ -80,7 +82,8 @@ properties: samsung,pll-clock-frequency: $ref: /schemas/types.yaml#/definitions/uint32 description: - DSIM oscillator clock frequency. + DSIM oscillator clock frequency. If absent, the driver will + use the clock frequency of sclk_mipi. phys: maxItems: 1 @@ -134,9 +137,7 @@ required: - compatible - interrupts - reg - - samsung,burst-clock-frequency - samsung,esc-clock-frequency - - samsung,pll-clock-frequency allOf: - $ref: ../dsi-controller.yaml# -- 2.39.2