Doesn't work when CW is on the rig control port and PSK31 uses a different port. May work with LPT poet but not with different serial ports... -=Rog-K9RB=-
----- Original Message ----- From: "Martin De Craemer" <[EMAIL PROTECTED]> To: <dx4win@mailman.qth.net> Sent: Sunday, October 26, 2003 12:41 PM Subject: Re: [Dx4win] PSK31 support for LPT keying > Hi Larry > > All you have to do is set the PTT delay to 500ms > and you can use both functions with CW control enabled > in the PSK window > > 73 Martin > > ON6MX > > ----- Original Message ----- > From: "Roger Borowski" <[EMAIL PROTECTED]> > To: "Larry Gauthier (K8UT)" <[EMAIL PROTECTED]>; <dx4win@mailman.qth.net> > Sent: Sunday, October 26, 2003 3:43 PM > Subject: Re: [Dx4win] PSK31 support for LPT keying > > > > Larry, In Ver 6.0x, you have to geo into "Preferences" and "Control" and > > switch the configuration from CW to PSK31 PTT and back and forth depending > > on the mode you are using at the moment. In Ver. 5.02/03 the PTT keying > port > > was selectable in the PSK31 window. Now its a real pain to switch between > > these modes as it requires you to go into Preferences and control each > time > > you change modes. I've alerted Paul numerous times about this and > hopefully > > it will be addressed in the next maintenance release. > > 73, -=Rog-K9RB=- > > > > ----- Original Message ----- > > From: "Larry Gauthier (K8UT)" <[EMAIL PROTECTED]> > > To: <dx4win@mailman.qth.net> > > Sent: Sunday, October 26, 2003 6:25 AM > > Subject: [Dx4win] PSK31 support for LPT keying > > > > > > > Due to a shortage of serial ports, I use LPT1 to key CW in DX4WIN. This > > > works fine for CW, but when operating in PSK31 mode, the LPT keyed line > > does > > > not seem to operate. I have gone into the PSK Tx preference window and > > > checked the "use CW control" - but the LPT CW line does not work from > PSK. > > > (the frustrating fact is that PSK keying _does_ work under exactly the > > same > > > settings from the COM port - but my com ports are dedicated to other > > > functions). > > > > > > Am I doing something wrong here ? > > > > > > -larry > > > K8UT > > > > > > _______________________________________________ > > > Dx4win mailing list > > > Dx4win@mailman.qth.net > > > http://mailman.qth.net/mailman/listinfo/dx4win > > > > > > > _______________________________________________ > > Dx4win mailing list > > Dx4win@mailman.qth.net > > http://mailman.qth.net/mailman/listinfo/dx4win > > > > > > > _______________________________________________ > Dx4win mailing list > Dx4win@mailman.qth.net > http://mailman.qth.net/mailman/listinfo/dx4win >