Thanks, everyone, for your suggestions. My comments below... Martin -- I have a rig that allows PTT and CW control on the same line, but that does not help me if the software doesn't key the line under PSK. I attempted your suggestion regarding setting the PTT delay for 500, but 6.02 allows no number higher than 255. Are you running a different version of the software or a different PSK DLL???
Roger -- Thanks for the validation -- I was certain that I used to be able to switch modes from SSB to CW to RTTY to PSK without any reconfiguration - but that must have been under version 5.x (I haven't run PSK in quite a while). Looks like I have to wait until a maintenance release is issued... -larry K8UT ----- Original Message ----- From: "Roger Borowski" <[EMAIL PROTECTED]> To: "Larry Gauthier (K8UT)" <[EMAIL PROTECTED]>; <dx4win@mailman.qth.net> Sent: Sunday, October 26, 2003 9:43 AM Subject: Re: [Dx4win] PSK31 support for LPT keying > Larry, In Ver 6.0x, you have to geo into "Preferences" and "Control" and > switch the configuration from CW to PSK31 PTT and back and forth depending > on the mode you are using at the moment. In Ver. 5.02/03 the PTT keying port > was selectable in the PSK31 window. Now its a real pain to switch between > these modes as it requires you to go into Preferences and control each time > you change modes. I've alerted Paul numerous times about this and hopefully > it will be addressed in the next maintenance release. > 73, -=Rog-K9RB=- > > ----- Original Message ----- > From: "Larry Gauthier (K8UT)" <[EMAIL PROTECTED]> > To: <dx4win@mailman.qth.net> > Sent: Sunday, October 26, 2003 6:25 AM > Subject: [Dx4win] PSK31 support for LPT keying > > > > Due to a shortage of serial ports, I use LPT1 to key CW in DX4WIN. This > > works fine for CW, but when operating in PSK31 mode, the LPT keyed line > does > > not seem to operate. I have gone into the PSK Tx preference window and > > checked the "use CW control" - but the LPT CW line does not work from PSK. > > (the frustrating fact is that PSK keying _does_ work under exactly the > same > > settings from the COM port - but my com ports are dedicated to other > > functions). > > > > Am I doing something wrong here ? > > > > -larry > > K8UT > > > > _______________________________________________ > > Dx4win mailing list > > Dx4win@mailman.qth.net > > http://mailman.qth.net/mailman/listinfo/dx4win > > >