i have seen that many have problems one or other way with rig control.
Dx4win is not the problem the most of the time. But maybe it's time Paul and
dx4win supports omnirig, a free cat control program. It would be an
alternative in every case... Either for a new rig or even to check if there
is a problem in dx4win or in your radio (this can be done and today).
Besides this someone will have the ability to run 2 programs which both
support omnirig the same time... Just a wish.... see omnirig here
http://www.dxatlas.com/omnirig/
Kostas sv1dpi
----- Original Message -----
From: "Joe Stepansky" <[EMAIL PROTECTED]>
To: <dx4win@mailman.qth.net>
Sent: Saturday, November 15, 2008 10:51 PM
Subject: [Dx4win] DX4Win doesn't recognize the rig
For whatever reason, my newly installed DX4Win 7 won't see my rig. I had
no
problem with version 6, but I've seemingly tried everything and it won't
go.
I'm running this through RigBlaster PRO. All the connections appear to be
fine (nothing changed between the time my old computer went bye-bye and
this
one). I'm connected from Serial In/Out A to COM1. Rig control on the
Rigblaster is connected to CI-V remote jack on the 756 PRO II. Here's the
set up under the Preferences/Radio tab:
Type - Icom 756 PRO II
Address - 64 (I've verified the address on the rig screen)
Baud - 9600
Com Port - COM1
Poll Rate - 5000
Max Tries - 6
DTR High - Off (When I leave this on the rig keys continuously)
RTS High - Off (When I leave this on the PTT is on continuously)
Any ideas?
73, Joe KQ3F
--------------------------------------------------------------------------------
_______________________________________________
Dx4win mailing list
Dx4win@mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dx4win
_______________________________________________
Dx4win mailing list
Dx4win@mailman.qth.net
http://mailman.qth.net/mailman/listinfo/dx4win
