Bob Just a point, but if you make the Prefix column slightly wider perhaps there is then room to display VP8G in the column?
Did you add VP8GEO to the prefix mapping table before or after logging the QSO? To be accurate you should have added it to the "Call Map" tab in the Prefix database. If u added it since the QSO was logged you need to go the QSO in the log and change the Prefix manually from VP8 to VP8G. DXBase does not act retrospectively on QSOs. If u change it manually be sure to save the change by pushing F10 or clicking in another cell of the same or another QSO. Try doing a Table Initialise? To give u hope, I worked VP8GEO on 12m, when I logged the QSO I changed it to VP8G from VP8 that DXBase suggested, and was prompted to save that mapping call. All my stats and tables are correct so it DOES work! 73 Fred G4BWP - K6BWP - 9G5FH - XT2WP ----- Original Message ----- From: "Hess, Robert P" <[EMAIL PROTECTED]> To: "'DXBase'" <[email protected]> Sent: Monday, February 04, 2002 6:46 PM Subject: [DXBase] South Georgia Logging Problem > Please ignore my previous post. > > > I have a problem getting DXBase 2002 to accept VP8GEO as South Georgia. It > wants to default to Faulklands. > > I have added VP8GEO to the prefix mapping table as South Georgia. > > I verified in the raw totals that my QSOs with VP8GEO have been recognized > as South Georgia. > > When I highlite the QSO in the log, it shows as South Georgia, but the > prefix shows as VP8. > > When I call up the Numeric Totals, it says I have not worked South Georgia > and the totals do not reflect a new country. > > What am I doing wrong? > > Bob > W1RH > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase >
