Yes, I am using the W5XD keyer, and successfully.... As a matter of fact, I got it woorking before it was working with writelog. Setup here is p266 with 8m of ram, TS850 on com 2, and keyer on com 3 Chuck/K0XM ----- Original Message ----- From: "AA6JJ - Jim" <[EMAIL PROTECTED]> To: "Ron Stordahl" <[EMAIL PROTECTED]>; <[email protected]> Sent: Sunday, March 31, 2002 8:47 PM Subject: Re: [DXBase] Using the W5XD Multi Keyer with DXBase
> At 2/20/02 04:01 Wednesday, you wrote: > >I am successfully using the new W5XD Multi-Keyer with WriteLog, the > >contesting program. However with DXBase it does not work, and in fact when > >typing some CW into DXBase the program locks up, apparently awaiting I/O > >completion. > > > >The MultiKeyer uses a single COM port to both do radio control and CW > >generation, and I am using COM1 at 9600. > > > >I suspect the problem could be that DXBase supports the old W5XD keyer, not > >the new W5XD Multi-Keyer. The WriteLog program supports both the old and > >the new, and if I set WriteLog for the old keyer, then it does not work with > >WriteLog either. > > > >But if anyone has gotten DXBase2002 to work with the W5DX Multi-Keyer please > >let me know. > > > >If a change is needed in DXBase, then I will have to rely upon Jack to put > >this in the next release? > > > >Ron N5IN > > Ron and group: > > I too have successfully used the W5XD Multi-Keyer in Writelog. > I too am having the same problem you describe in using it in DXBase 2002. > Has anyone successfully implemented using the keyer in DXBase 2002? > Please let me know. > Thanks, > Jim AA6JJ > > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase
