Not sure what the question is? To make the packet tnc work with your rig and DXB, you must have the tnc connected to the computer via a com port and the rig connected to the tnc. Been a while since I hooked up my tnc but I know you have to connect audio in and audio out wires as well as a ptt. I'm sure you can make some sort of adapter that plugs into the mike connector. Doesn't the Icom have a connector on the back that accepts a tnc connection?
----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[email protected]> Sent: Saturday, April 13, 2002 9:13 AM Subject: [DXBase] PACKET INTERFACE WITH ICON IC-2100 > Hello All: > I may have sent this call for help before. However, in that I did not > received a single response, maybe it didn't go out. > > I am new to the DXBASE software and learning every day. I recently > bought an ICOM IC-2100 two meter rig and would like to interface it with a > Kantronics KPC3. The radio has one of those new telephone type microphone > connectors. . . . . so I was wondering if anyone out there had been in the > environment and had the answer. Marty. > > > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase > >
