I should have mentioned in my first message the rotor control works fine in COM 1 & 2. However I need one com for the radio, and two coms for two rotors. So, I need a minimum of three working com ports. The radio does the same thing as the rotor, only works in com 1 & 2 in DXBase 2004. The radio works in all com ports in DXBase2002.
I recently upgraded from 2002 to 2004. The rotor control works fine in 2002. When I attempt to rotate the ant in 2004, the program locks up. I've double/triple checked the setting and they are exactly the same as in 2002. I have been using com4. I tried writelog using the same com port for rotor control and it works fine. I tried moving the rotor control to com3..The same problem, it works fine in 2002 and not in 2004 everything locks up. I have two makes of rotors one is M2 the other is Yaesu 1000sdx. I have the same problems regardless of which rotor I attempt to use. Both of them work in 2002, none of them work in2004 in com4 or com3. I did and redid the DXB drive setup..no luck. When the program locksup I have to do the Cntrl, Alt, del and get the "DXbase not responding" message. Anyone have some ideas or suggestions about this problem. Len, K6ANP --- StripMime Report -- processed MIME parts --- multipart/alternative text/plain (text body -- kept) text/html The reason this message is shown is because the post was in HTML or had an attachment. Attachments are not allowed. To learn how to post in Plain-Text go to: http://www.expita.com/nomime.html ---
