Sounds like comport trouble to me. Please list the following: 1. What is each comport being used for? 2. What other software is running at same time as DXbase? 3. Do you have a modem installed and if so, what comport is it assigned to?
This will possibly help diagnose the conflicts. Regards, Courtney ----- Original Message ----- From: "k6anp" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Sunday, April 27, 2003 7:38 PM Subject: [DXBase] Com Port problems > I should have mentioned in my first message the rotor control works fine in > COM 1 & 2. However I need one com for the radio, and two coms for two > rotors. So, I need a minimum of three working com ports. The radio does the > same thing as the rotor, only works in com 1 & 2 in DXBase 2004. The radio > works in all com ports in DXBase2002. > > I recently upgraded from 2002 to 2004. The rotor control works fine in > 2002. When I attempt to rotate the ant in 2004, the program locks up. I've > double/triple checked the setting and they are exactly the same as in 2002. > I have been using com4. I tried writelog using the same com port for rotor > control and it works fine. > I tried moving the rotor control to com3..The same problem, it works fine > in 2002 and not in 2004 everything locks up. I have two makes of rotors one > is M2 the other is Yaesu 1000sdx. I have the same problems regardless of > which rotor I attempt to use. Both of them work in 2002, none of them work > in2004 in com4 or com3. > I did and redid the DXB drive setup..no luck. When the program locksup I > have to do the Cntrl, Alt, del and get the "DXbase not responding" message. > > Anyone have some ideas or suggestions about this problem. > > Len, K6ANP > > > > --- StripMime Report -- processed MIME parts --- > multipart/alternative > text/plain (text body -- kept) > text/html > The reason this message is shown is because the post was in HTML > or had an attachment. Attachments are not allowed. To learn how > to post in Plain-Text go to: http://www.expita.com/nomime.html --- > _______________________________________________ > DXBase Reflector - Please visit us on the web at www.dxbase.com > - - - - - - - - - - - - - - - - - - - - - - - > To UNSUBSCRIBE please visit: > http://mailman.qth.net/mailman/listinfo/dxbase >
