See a tree test I made some time ago, it' doesn't
use DynAPI, and isn't very good, but might give you some ideas:
I've made a low memory one in DynAPI as well, but
it's not on the net yet, I used one dynlayer, and wrote
hyperlinks to it in a loop, with a + in front
where necessary, which performed the loop again when clicked. It's not
When do we get to see it? :-)
This is another treeview you can check
out:
Checked it out.. (came across it before actually)
Problem with that one is that it re-draws the whole
tree
when you expand/collapse a node.., and when you have 300+
nodes
you
can imagine how that would be bad..
:-)
Doug
good luck
Richard:)
Thanks, I've needed
it..
You
can check out what I've got so far by going to
206.75.45.190
and
clicking on catalogue (after clicking enter of course)
----- Original Message -----
Sent: Monday, December 11, 2000 3:12
AM
Subject: [Dynapi-Help] ARG!!! or: Gotta
little problem with a div...
Okay then, AS you may recall, I have been
messing around with trees..
Now, since the skintree node was Way slow (and
caused a 10 meg memory leak after 4 reloads in IE) I had to find anothewr,
now I have. The main problem with the one I am using, is that the entire
tree is built in memory and THEN the induvidual divs (yes it used plain
divs) are written out and rendered..
This is all fine and dandy, I figure I'll just
load a 'splash' screen into a loadpanel and distract the user while the tree
is rendered.. Now I have just one problem, I need to
be able to put the HTML that makes the tree up
into a div (mainDIV)..
How do I do that? if I wasn't using dynAPI (I'm
using it for the loadpanel and scroll) I wuold do it normally,
But it seems that dynAPI overload the normal
method of referencing and modifying an object..
Well, to cut an already way too long message a
bit short..
How do I reference and modify a 'normal' DIV
throught the DynAPI?
Doug
Melvin
