Please do not reply to this email, use the link below. http://bugs.ecos.sourceware.org/show_bug.cgi?id=1001219
--- Comment #62 from Jerzy Dyrda <[email protected]> --- Hello Ilija, (In reply to comment #61) > (In reply to comment #60) > > (In reply to comment #59) > > > I was about to commit but in the last check I noticed something that needs > > > explanation. > > > > > > The function hal_stm32x0_led(). I assume there is some conflict with > > > ethernet. Please explain. > > > > > > There must be better solution that deletting 3 leds. > > > > > > 1. Make compilation conditional, so LEDS are in use when possible and > > > ommitted otherwise. > > > > > > 2. Remove this function completely. or replace it with new. (I wouldn't > > > reccommend this). > > > > > > If above assumption is not correct, there may be other solutions as well. > > Sorry I omitted it during checking. This was used by me only for my debug > > purpose. Development board, which I used, has only one LED. > > Please skip this change it's absolutely not needed by driver. > > > > For avoidance of doubt: I revert the code for this function to the state > before adding of Ethernet driver. Yes. Please. Best regards, jerzy -- You are receiving this mail because: You are on the CC list for the bug.
