do a Fill command wiht If stament or is it different codes..?
if different codes us a XREF table, look in the book under lookup..
WDM
-----Original Message-----
From: Pam Lloyd [mailto:[EMAIL PROTECTED]]
Sent: Thursday, October 05, 2000 4:41 PM
To: Mojica William-FWM008; [EMAIL PROTECTED]
Subject: RE: Thursday, October 5, 2000 ---- Harbinger Trust Li nk Window
- STMA P version 4.34 - 810 - outbound transaction
Thank you for responding Mojica. This is I did to make it work.
Basically, I told my mapping to process anything Not Equal "NE" to the BY
segment.
I went to the N1 Mapping - Segment
and told it to the following:
Condition One - I requested record 09 which was my N1
Then I called up the "Select Relational Operator" and selected "NE"
And set string variable to be BY.
Then I applied the same application to the N3 and the N4 segment.
And it worked. (to my surprizzzzze it worked)
Now I have to figure out how to make the have a specific code only appear on
the N104 segment on the RI segment.
-----Original Message-----
From: Mojica William-FWM008 [mailto:[EMAIL PROTECTED]]
Sent: Thursday, October 05, 2000 1:19 PM
To: Pam Lloyd; [EMAIL PROTECTED]
Subject: RE: Thursday, October 5, 2000 ---- Harbinger Trust Li nk Window
- STMA P version 4.34 - 810 - outbound transaction
unfortunately Harbinger has not implemented the (smart) logic If... Then...
Else.. therefore you must ask at every 09 record if 09ST.....do this ..,
then if 09RI Do that ... but do not ask if 09BY and it will be skipped, but
because Harbinger does not have if... then... else... you must do an IF
question before every command.
WDM
(hope that helps)
-----Original Message-----
From: Pam Lloyd [mailto:[EMAIL PROTECTED]]
Sent: Thursday, October 05, 2000 4:04 PM
To: [EMAIL PROTECTED]
Subject: Thursday, October 5, 2000 ---- Harbinger Trust Link Window -
STMA P version 4.34 - 810 - outbound transaction
810 transaction going outbound.
Right now my mapping is sending out the BY, ST, and the RI. My customers is
now asking me to not send the BY segment. And add a code to my N104 but the
code must appear on the RI line only.
Question is how to I structure my mapping do the following: if it see the
'BY' segment to ignore it and pick up the ST and the RI. Then place a
specific code on the N104 segment on the RI line??
09BYJANEDOE FASTENERS
102045 SAGEBRUSH ROAD
12MEDFORD OR97501 US
09STJANEDOE FASTENER 92
102222 QUINES CREEK
12MEDFORD OR97410 US
09RIPorteous Fastener Company
10123 MAINTEXT STREET
12SAN PEDOR CA90051-0608 US
Pamela LLoyd
EDI Coordinator
310-847-6784
=======================================================================
To signoff the EDI-L list, mailto:[EMAIL PROTECTED]
To subscribe, mailto:[EMAIL PROTECTED]
To contact the list owner: mailto:[EMAIL PROTECTED]
Archives at http://www.mail-archive.com/edi-l%40listserv.ucop.edu/
=======================================================================
To signoff the EDI-L list, mailto:[EMAIL PROTECTED]
To subscribe, mailto:[EMAIL PROTECTED]
To contact the list owner: mailto:[EMAIL PROTECTED]
Archives at http://www.mail-archive.com/edi-l%40listserv.ucop.edu/
