Hi I use a small square of double stick foam tape for RFC11 and T2 in the transmitter. This tape is about 1/16 inch thick so it works on T2 to mount it up above the board a little to improve the output on 10 meters.
Don Brown ----- Original Message ----- From: Linden, Mike (BRC-Hes)<mailto:[EMAIL PROTECTED]> To: 'elecraft@mailman.qth.net'<mailto:'elecraft@mailman.qth.net'> Sent: Monday, June 14, 2004 8:49 AM Subject: [Elecraft] K2: RFC11 I'm looking for input on the winding and installation of toroid RFC11 which mounts underneath the K2's RF board. Assuming I wind RFC11 such that 85% of the toroid is used, I don't see how it can "easily" be secured by the leads given the location of the lead holes. How has this worked out for folks who have built their K2s? Thanks, Michael N9BDF K2 SN #4137 PS The "Amateur Radio Emergency Communications Consistency Act" (HR 1478) and the "Amateur Radio Spectrum Protection Act" (HR 713 & S. 537) are in Congress. Please contact your Congressmen to ask for their support of these bills! See the following ARRL link for details: http://www.arrl.org/govrelations/<http://www.arrl.org/govrelations/> <http://www.arrl.org/govrelations/<http://www.arrl.org/govrelations/>> _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net<mailto:Elecraft@mailman.qth.net> http://mailman.qth.net/mailman/listinfo/elecraft<http://mailman.qth.net/mailman/listinfo/elecraft> You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm<http://mailman.qth.net/subscribershtm> Elecraft page: http://www.elecraft.com<http://www.elecraft.com/> _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com