Michael, I wound RFC11 exactly as directed by the instruction manual; and I had no problem. I even went downstairs and took the bottom cover off my K2 just to doublecheck. I am in the phase of aligning the filters befoere starting Assebly Part III of the RF board. If you're using the proper holes it shouldn't be a problem.
73 de Larry W2LJ - Vivat Morse! © ® [EMAIL PROTECTED] http://www.qsl.net/w2lj ARRL Lifemember QRP ARCI #4488 NJQRP #47 FISTS #1469 QRP-L #778 FP #612 QRPp-I #759 ARS #1528, AmQRP, CQC #746 K1 #1647 - K2 #4090 for QRP Icom IC-751A for QRO Butternut HF9V and G5RV antennas ----- Original Message ----- From: "Linden, Mike (BRC-Hes)" <[EMAIL PROTECTED]> To: <elecraft@mailman.qth.net> Sent: Monday, June 14, 2004 9:49 AM Subject: [Elecraft] K2: RFC11 > I'm looking for input on the winding and installation of toroid RFC11 > which mounts underneath the K2's RF board. Assuming I wind RFC11 such that > 85% of the toroid is used, I don't see how it can "easily" be secured by the > leads given the location of the lead holes. How has this worked out for > folks who have built their K2s? > > Thanks, Michael N9BDF > K2 SN #4137 > > > PS The "Amateur Radio Emergency Communications Consistency Act" (HR 1478) > and the "Amateur Radio Spectrum Protection Act" (HR 713 & S. 537) are in > Congress. Please contact your Congressmen to ask for their support of these > bills! See the following ARRL link for details: > http://www.arrl.org/govrelations/ <http://www.arrl.org/govrelations/> > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > http://mailman.qth.net/mailman/listinfo/elecraft > You must subscribe to post. > Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm > Elecraft page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net http://mailman.qth.net/mailman/listinfo/elecraft You must subscribe to post. Subscriber Info (Addr. Change, Unsub etc): http://mailman.qth.net/subscribers.htm Elecraft page: http://www.elecraft.com