The easiest solution to bassy SSB is CW.
best wishes,
dave belsley, w1euy
On Sep 23, 2004, at 2:52 PM, Ron D'Eau Claire wrote:
Shift the BFO frequencies so your spectrogram display shows that you
are
cutting off a bit more of the low end (end nearest the carrier) and
leave a
little more of the high frequencies (farthest from the carrier) inside
the
bandpass.
Spectrogram is great, but I'd never count on a scope display to tell
me what
my signal really sounds like! The final settings are just too precise
and
vary with the mic you are using and your "ear". That's why the SSB
module
instructions advise listening to your signal and making the final
"tweaks"
of the BFO frequencies based on what you hear, not what you see.
Remember, only tweak the BFO frequency settings for OPT1. No other
filter/BFO setting combination is used for xmit, no matter what filter
you
have selected for receive.
Ron AC7AC
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Michael van
Hauten
Sent: Thursday, September 23, 2004 10:05 AM
To: elecraft@mailman.qth.net
Subject: [Elecraft] SSB-TX-Signal is too bassy
Hi,
my SSB signal is a little bit too bassy after i have modified my
ssb-modul
from 2.0 to 2.5khz. The filter setting for TRX is OP1 in receive mode
with
lsb and seems with spectrogram full in range between 0.2 and 2.5khz.
What is
to adjust?
tnx for your help
Michael, DC0ZO
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com