Is this the time to consider the 14 matched xtals? I bought a set at the time I installed my SSB unit (which was well after the basic K2 was built). I still haven't traded out the original xtals for the new ones in the K2, but once I do they will match the SSB's xtals.
Tom WB2QDG K2 #1103 When a clock is hungry, does it goes back four seconds? -----Original Message----- From: [EMAIL PROTECTED] <[EMAIL PROTECTED]> To: elecraft@mailman.qth.net <elecraft@mailman.qth.net> Date: Saturday, October 02, 2004 12:13 PM Subject: [Elecraft] Suggestions for tweaks while building K2 and KSB2 Hello folks, I'm new to the list, and have just began assembling my newly purchased K2, and KSB2. I'm looking for suggestions of things I can do while in the process of building the K2 and KSB2 that may help avoid some of the issues that have come up with other users. Here's what I've come up with so far: (mostly from viewing LA3ZA's web site, and monitoring the list the last couple of weeks) -Ground the mic jack outer conductor -Ground the SSB filter crystals near the bottom of the can instead of on the top -Pay close attention to windings on T2 and T4 while they're being built in order to have full output on 10m Anyone have any other suggestions? Thanks. -Ben KB1AHR _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com