On Mon, 07 Feb 2005 16:36:52 +1300, ZL1TW wrote: > > > When I replaced the screws on my K2/100, I drilled a hole right through > the heat-sink rail on the KPA100 at the middle screw mounting, and tapped > it for 4-40 and installed a bit longer screws. > No messing about with inserts, quick and easy, and is not noticeable. Just > need the appropriate tap. > Cheers......Ron ZL1TW
My mod to the heat sink was to enlarge the middle holes with a drill, and insert suitably sized nuts secured in place with epoxy resin glue. No worries. 73 Stewart G3RXQ _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com