Am getting a bit fed up of my K2 scratching it's brother (KPA100/KAT100 in EC2 case) and a FT1000MP - well forget the last one.. Might do the countersink mod some time.
73 Stewart G3RXQ On Mon, 7 Feb 2005 10:02:40 -0000, Geoffrey Mackenzie-Kennedy wrote: > Don't want to drag this out, but I am with you Ron. I find that the "warts" > > give the K2/100 an "unfinished" look, stands out like a sore thumb against > most other gear in the shack. I hope that any new products that might come > from Elecraft will NOT have "warts". > > 73, > Geoff GM4ESD > > ----- Original Message ----- > From: "ZL1TW" <[EMAIL PROTECTED]> > To: <elecraft@mailman.qth.net> > Sent: Monday, February 07, 2005 3:36 AM > Subject: [Elecraft] Re: KPA100 middle screw alteration > > >> When I replaced the screws on my K2/100, I drilled a hole right > through >> the heat-sink rail on the KPA100 at the middle screw mounting, and tapped >> it for 4-40 and installed a bit longer screws. >> No messing about with inserts, quick and easy, and is not noticeable. Just >> need the appropriate tap. >> Cheers......Ron ZL1TW >> > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com