John, Since you seem to be certain of the cable -- Check the voltage at KIO2 or KPA100 AUX I/O pin 8 - it should be 12 volts. If it is not (and you have the KIO2), check to see if the RFChoke L1 on the KIO2 board is open.
When plugged into a powered on K2, all connectors on the cable should have 12 volts on pin 8. 73, Don W3FPR John Hoaglun wrote: > Hi Peter & the list, > > That was my initial first guess too. I looked at the numbers in the > molded plastic (since it is accurate on both sides) and then tested them > with a DVM to make sure that they matched at all four ends (K2, 144, > 222, 432) and they do. I need to go run a couple of errands this > afternoon. Just for grins I will stop at RShack and see if they have a > couple of DP9's on the shelf. If so I will likely make up a quick cable > that I can use for direct K2 to one transverter for bench testing. (I am > crossing my fingers that it is something simple like that.) > > FYI... I just went back to the work bench, swapped the JP7 & JP8 jumpers > and then disabled the DIP that controls the resistor network for the TRN > address, power cycled them and all three transverters respond as > expected. Of course I would prefer to use them with the K2 for auto > switching so I will need to figure this out. > > Please keep sending me your ideas. I will see if I can get the parts to > make a test cable this afternoon. (50 miles round trip for 2 DB9... > becomes an expensive part.) > > 73 > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
