Ok Val. I just tend to go with what the designers specify and that is why I use their specified 1 stop-bit.
73, Tom - W4BQF -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Val Sent: Thursday, September 16, 2010 10:19 AM To: elecraft@mailman.qth.net Subject: Re: [Elecraft] K3 - CONFIG question Tom, I am using SD contest logger, where 2 stop bits were set by default for K3. That's why now I set N1MM on my second computer the same way. Actually K3-N1MM connection works fine here with 1 or 2 stop bits set, no difference. 73 Val LZ1VB > Val -- That is good information, but why 38400/N/8/2 ? My manual says the > stop-bits should be set to '1' ? Is your keying working with N1MM the way > you have it? > > 73, > Tom - W4BQF > Subject: Re: [Elecraft] K3 - CONFIG question > > Poul-Erik, > > I have here K3 PTT-KEY as OFF-DTR and N1MM as 38400, N,8,2, DTR-CW, > RTS-Always Off. > > 73 Val LZ1VB > > >>What are the correct settings of the K3 and of N1MM for keying (CW) the K3 >>from N1MM? >>Sorry if this has been answered in the past - if so pse just a link. >>Poul-Erik, OZ4UN ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html