Hi all,

Thank you for the suggestion about ANT2.  I had inadvertently switched 20M
over to the unterminated ANT2 connector.  All is well now.  Assuming I don't
get written up for transmitting 20 or 30 minutes of 25 wpm dots at 14.001
MHz (hi).  I had the Bencher contacts locked down tightly, but I guess I had
the spacing too close for the paddle's tolerances (it was cool in the
shack).

73,

Phil, NS7P

-----Original Message-----
From: Tom Hammond [mailto:n...@embarqmail.com]
Sent: Saturday, September 18, 2010 3:57 PM
To: Phil and Christina
Subject: Re: [Elecraft] Problem with my K3


Phil:

Any chance you might have, by accident, switched to an empty ANT2...???

73,

Tom  N0SS

At 17:33 09/18/2010, you wrote:
>I need some advice.  I had the K3 on this afternoon and tuned to the low
end
>of 20M (about 14.001x).  I had been going into and out of the shack with
the
>radio in receive mode.  I went into the shack and heard a continuous string
>of dots.  I tried to tune the signal, only to realize that it was my
>sidetone (the watt meter in the SB200 was bouncing).  I had to turn off the
>power supply to stop it.  When I powered it back on, the ERR KEY message
was
>displayed.  I looked it up and saw that the key line must be active at
power
>on.  I disconnected the Bencher paddle, and the ERR message went away.  It
>appears that the dot contact on the Bencher had changed enough to make it
>touch.  I adjusted the paddle, and that problem went away.
>
>The problem now is that on 20M, keying the radio gives a HI SWR message and
>the SWR indicates 99.9:1.  This is with either the 20M antenna or a dummy
>load.  The other bands appear to be fine.  I fear that I may have fried
>something in the 20M output circuit.  Any suggestions?  Help please!
>
>73,
>
>Phil, NS7P
>
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: mailto:Elecraft@mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html

______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html

Reply via email to