Have you tried restarting the PC as well, or can't you get the K3 to work, after the reset?
Bill K9YEQ -----Original Message----- From: elecraft-boun...@mailman.qth.net [mailto:elecraft-boun...@mailman.qth.net] On Behalf Of David Carlson Sent: Saturday, September 25, 2010 5:46 PM To: elecraft@mailman.qth.net Subject: [Elecraft] K3 Froze My K3 froze up while downloading in The K3 utility program. The LED shows "MCU LD" and the red TX light is blinking under the power switch. I can not turn the power off with the power switch. I have to turn off the power supply. The K3 utility program can not communicate with the K3 so I can't reinstall the firmware code, however the P3 utility program can connect. I have tried turning off the K3 and then turning it back on holding the "shift/lo" button to reset. That does not work. I did download the latest K3 utility program. Any suggestions? Thanks ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html