This is during upgrading a K3/10 to a K3/100. The PAIO test is done before the PA3 is installed. And yes I made sure the red wire was on the pin with the silk screened word red behind it.
I haven't taken time to study the schematics yet or take voltage readings. David K0LUM At 8:16 AM +0800 12/12/10, Johnny Siu wrote: >Hello David, > >Could you take out the KPA3 module and just >leave the PAIO board? Do the test again so that >we can determine whether the problem is solely >coming from the PAIO board. > >The PAIO board can work without the power module >and the K3 can function in QRP mode? > >BTW, do you install the fans connector in the >correct way (beware of the position of the red >wires)? > > >cheers, > >Johnny VR2XMC > >--- 2010îN12åé12ì êØäìÅCDavid Christ <radio...@mchsi.com> õçì¼: > > > > Bad 24 hours. Last night we hit >> a deer. Tonight while installing a >> KPA3 in my K3 it fails the PAIO tst. No relay click. >> No fan action. >> Can't contact Elecraft until Monday. >> >> Any suggestions to try over the weekend would be >> appreciated. >> >> David K0LUM >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:Elecraft@mailman.qth.net >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html