There's nothing wrong with the currents you're getting. What does your Watt/SWR meter say when you change power? Forget about how "loud" it sounds on the receiver. The econd receivers AGC could be clamping down to make the signal sound the same. I'll bet the S meter on the second receiver is going up.
To do transmitter testing you need a watt meter. On Fri, 6 May 2011 22:17:56 -0700 (PDT) Brian - N5BCN <n5...@yahoo.com> wrote: > Hi All, > > During the course of testing my recently built KPA100, I'm > experiencing odd results on the cw transmit tests. All tests, > resistance, and voltage checks up until this point have been normal. > > When transmitting cw into a 100 watt dummy load, things appear normal > when transmitting in QRP mode (below 11 watts). The strength of the > cw signal on a separate receiver increases in strength as does the > current draw up until the 11 watt level. > > When the K2 Power level hits 11 watts, the high power relay clicks > but the signal strength actually drops. At 20 watts, the signal > strength on the separate receiver is quieter than at 10 watts. > However, the current steadily increases and did not drop after the > high power relay kicked in. > > My approx current draw measurements at key down for various power > levels (measured by my power supply's meter): > > 5 W ~ 2 A > 10 W ~ 3 A > 15 W ~ 7 A > 25 W ~ 8 A > 50 W ~ 11 A > 100 W ~16-17 A > > My current draw during tune at less than 11 W is 343 mA (I have a > number of option modules, fixed audio output mod, and Z10000 output > buffer). > > My current draw during tune at 11 W plus the fan on low is 545 mA. > > I set the bias current so the current draw during tune at 11 W plus > fan on low is about 950 mA, although it rises pretty quickly to above > 1000 mA during tune. > > As always, many thanks for your thoughts and suggestions. > > 73 > > N5BCN - Brian > > ----- > K2 #6800 KPA100/KAT100-2, KSB2, KAT2, KIO2, K160RX, KNB2, KAF2, > LP-PAN/K2 w/ Pre-amp, SignaLink USB -- > View this message in context: > http://elecraft.365791.n2.nabble.com/K2-KPA100-transmit-test-fail-tp6339548p6339548.html > Sent from the Elecraft mailing list archive at Nabble.com. > ______________________________________________________________ > Elecraft mailing list Home: > http://mailman.qth.net/mailman/listinfo/elecraft Help: > http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html -- R. Kevin Stover AC0H ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
