I'd like some confirmation of this. I can see in the KPA500 manual (rev A, page 16) that pin 11 of the AUX connector is INHIBIT#. That's fine. Pin 11 on the K3 AUX connector is DIGOUT1, OK. However, also in the KPA500 manual (page 17), the wiring for a cable between the K3 and the KPA500 does not use pin 11. I have constructed my K3-KPA500 AUX cable according to this table, in anticipation of receiving my KPA500 kit later this summer. If this table is correct, I cannot see how DIGOUT1 affects the KPA500. If in fact, It does inhibit the KPA500 (auto-magically, without being connected), does this mean that DIGOUT1 can no longer be used to control the PR6 preamp, when a KPA500 is connected to a K3? Somewhat confused in NH, Bruce, N1RX > Make sure that DIGOUT1 is turned OFF from the K3. Turning it on disables the KPA. Note that this is a per-band function, so it needs to > be turned off for each band you wish to use the KPA500. > Jack Brindle, W6FB
______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html